The process of adding USB 2.0 ports took no time and the backup system is mighty fast. If you add USB 2.0 ports with a PCI port card, then you'll still have your USB 1.1 ports, so whatever is plugged into those can stay.

Rob Foster from the UK sent me a port PCI USB card since he had a few extras. Thanks again, Rob. When installing hardware or devices, most situations require loading the software FIRST before doing anything else. This one didn't - so be sure to check this out before attempting to put the card in. Before starting the process, be sure you have an open PCI slot, a standard slot that has one big connector with a small one behind it.

Turn off the computer, if it is not already. Take off the CPU case. How this is done depends on the CPU. If you lost or misplaced the manual, I'm sure your computer manufacturer has info online. Google it, if needed. Slide the PCI card into the open PCI slot.

At this point, you can cover up the CPU, but some people leave it off until turning on the computer and checking all is OK. When turning on this little feller, it found the new card right away and worked. I didn't even have to run the software. The card came with four USB ports, one of which holds the backup system. It took under two hours to back up the computer (get size), faster and easier than the tape back up.

Well, it only took a year or so to get around to adding the USB 2.0 ports as that's about how long the back up system has been sitting here taunting me.